Chris Corrales
- Total activity 24
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 17
Activity overview
Latest activity by Chris Corrales-
Chris Corrales created an article,
Changing your CNC network IP Address
Changing or updating your IP Address CNC Factory machines come with a static IP address that can not be changed by default. If connecting to an existing LAN make sure the IP address is not interfe...
-
Chris Corrales created an article,
Windows Update
Updating Windows on your machine can cause the network or communications settings to change and communication to stop with your CNC. If this happens follow the attached PDF instructions to re-esta...
-
Chris Corrales created an article,
Vacuum Table Material Release and settings
Vacuum Table Release Adjustments If the material is still holding suction after master Vacuum Flow is turned off or during unloading with the unloading arm, verify zones and or adjust parameters as...
-
Chris Corrales created an article,
Changing Tool Diameter or Length
Changing Tool Diameter or Length Accessing Tool diameter or length screen press ESC 3 times At any menu select F4 Monitor from the bottom tab line At monitor screen choose F5 Tool Wear Set You ca...
-
Chris Corrales created an article,
ATC push out or retract sensor
Error codes: MLC76, MLC77, MLC81, MLC83, R44.11, R44.12, R45.0, R45.2 The sensor that verifies the ATC is back in place or extended for tool change is not activating the sensor signal telling the m...
-
Chris Corrales created an article,
Drill Block Plate location sensor signal
MLC87 or R45.6 Error Codes The drill block sensor located at top of drill cylinder is not responding or needs to be adjusted. The red led light should activate on the sensor telling the machine th...