Avatar

Chris Corrales

  • Total activity 24
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 1
  • Subscriptions 17

Articles

Recent activity by Chris Corrales Sort by recent activity Recent activity Votes
  • Changing your CNC network IP Address

    Changing or updating your IP Address CNC Factory machines come with a static IP address that can not be changed by default.  If connecting to an existing LAN make sure the IP address is not interfe...

  • Windows Update

    Updating Windows on your machine can cause the network or communications settings to change and communication to stop with your CNC.  If this happens follow the attached PDF instructions to re-esta...

  • Changing Tool Diameter or Length

    Changing Tool Diameter or Length Accessing Tool diameter or length screen press ESC 3 times At any menu select F4 Monitor from the bottom tab line  At monitor screen choose F5 Tool Wear Set  You ca...

  • Vacuum Table Material Release and settings

    Vacuum Table Release Adjustments If the material is still holding suction after master Vacuum Flow is turned off or during unloading with the unloading arm, verify zones and or adjust parameters as...

  • ATC push out or retract sensor

    Error codes: MLC76, MLC77, MLC81, MLC83, R44.11, R44.12, R45.0, R45.2 The sensor that verifies the ATC is back in place or extended for tool change is not activating the sensor signal telling the m...

  • Drill Block Plate location sensor signal

    MLC87 or R45.6 Error Codes The drill block sensor located at top of drill cylinder is not responding or needs to be adjusted.  The red led light should activate on the sensor telling the machine th...